which cisco ios switch command is used to configure the use of lacp on an interface?

The D character at the beginning of a line in a routing table indicates that the route has been learned via EIGRP.īy default, the network command uses a classful network as the parameter. You can verify that routes are indeed being exchanged by using the show ip route command on both routers: The interface field shows on which local interface the neighbor relationship has been formed. The address field lists the neighboring router RID (router ID). The command above lists all EIGRP neighbors. You can verify that routers have become neighbors by using the show ip eigrp neighbors command on either router: Here is the EIGRP configuration on R1 and R2: Each router has a directly connected subnet that needs to be advertised through EIGRP. The network depicted above consists of only two routers. To illustrate a configuration of EIGRP, we will use the following network: By default, the network command takes a classful network number as the parameter. The second command, network SUBNET, enables EIGRP on selected interfaces and specifies which networks will be advertised. ASN_NUMBER represents an autonomous system number and has to be the same on all routers running EIGRP, otherwise routers won’t become neighbors. The first command, router eigrp ASN_NUMBER, enables EIGRP on a router. telling EIGRP which networks to advertise by using one or more network statements.enabling EIGRP by using the router eigrp ASN_NUMBER command.EIGRP is not explicitly listed in the latest 200-301 version of the CCNA exam topics (whereas OSPF is) but you can still be tested on it in the exam.ĮIGRP configuration closely resembles RIP configuration.

Which cisco ios switch command is used to configure the use of lacp on an interface?